TOSHIBA DKT2000-Series

Microphone Sensitivity Controls

You can set the sensitivity of the microphone on 2000-series speakerphone models to adjust for the level of room noise.

HIGH-NOISE SENSITIVITY

If it is noisy around your station and people are cutting off while talking to you on your speakerphone, set your microphone for high-noise sensitivity.

To Set for High-Noise Sensitivity:

While holding down the Mic button, press the up Vol button for three seconds. The Mic LED should flash about six times while setting the sensitivity.
Confirm that the LED flash conforms to the desired mode of operation (Note 2).
NOTES:
  1. This procedure can be performed while idle or on a speakerphone call.
  1. When the microphone is set for high-noise sensitivity, the Mic LED will flash at the in-use rate when the telephone is busy on a speakerphone call.

NORMAL SENSITIVITY

The microphone should be set for normal sensitivity operation when the station is located in a normal office (low-noise level) environment.

To Set for Normal Sensitivity:

While holding down the Mic button, press the down Vol button for three seconds. The Mic LED should flash about six times while setting the sensitivity.
Confirm that the LED flash conforms to the desired mode of operation (Note 2).
NOTES:
  1. This procedure can be performed while idle or on a speakerphone call.
  1. When the microphone is set for normal sensitivity, the Mic LED will be lit steady when the telephone is busy on a speakerphone call.

 

Need phone support?